Owner manual

A-8

Step 9 - Attach the Seat Rail to the Main

Assembly

Locate the following items:

• From Step 4 - Main Assembly

• From Step 8 - Seat Rail Assembly

• Item #12 - Seat Rail Knob

• Item #J - (1) 3/8" X 4 1/4" Button Head Screw

• Item #N - (2) 3/8" Washers

• Item #O - (1) 3/8" Nylock Nut

• Item #Q - (1) Bolt Cover

Align the holes on the Seat Rail Assembly (from Step 8) with

the holes in the Rail Bracket on the Main Assembly (from

Step 4), as shown in Figure 9

Insert the Seat Rail Assembly into the Seat Rail Bracket,

and then place (1) 3/8" Washer (Item #N) over the end of (1)

3/8" X 4 1/4" Button Head Screw (Item #J). Insert the screw

through the aligned holes, as shown, and place (1) 3/8"

Washer and (1) 3/8" Nylock Nut (Item #

O) over the end of the

screw to secure.

Do not over-tighten the hardware from Step 9.

Note: Tighten the nylock nut enough that the threads

of the screw extend through the nylock nut, but

loosely enough that the Seat Rail Assembly can move

freely.

At this time, place (1) Bolt Cover (Item #Q) over the Nylock

Nut installed during Step 9. Then, thread the Seat Rail Knob

(Item #12) into the top hole on the Seat Rail Bracket, as

shown in Figure 9, but do not over-tighten.

Figure 9

Rail

Assembly

Main

Assembly

Seat Rail

Bracket

Assembly Guide