Owner manual

A-9

Step 10 - Attach the Leg Extension Pivot Tube

Locate the following items:

• Item #13 - Leg Extension Pivot Tube

• F

rom Step 9 - Main Assembly

• Item #30 - Lock Out Pin

• Item #G - (1) 3/8" X 2 3/4" Button Head Screw

• Item #N - (2) 3/8" Washers

• Item #O - (1) 3/8" Nylock Nut

• Item #Q - (1) Bolt Cover

Undo the twist ties from the Pivot Bushings. Align the holes located

on the “curve” of the Leg Extension Pivot Tube (Item #13) with the

holes on the bracket of the Rear Leg, as shown in Figure 10a.

Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X

2 3/4" Button Head Screw (Item #G). Thread the screw

through the aligned holes and bushings and secure by

placing (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item #O)

over the end of the screw, as shown in Figure 10a.

Do not over-tighten hardware from Step 10.

Place (1) Bolt Cover (Item #Q) over the Nylock Nut installed

during Step 10.

Note: When storing the Rail Assembly, insert the

Lock Out Pin (Item #30) through the holes in the

Pivot Tube to temporarily hold the Leg Extension in

place while folding the Rail up (see Figure 10b).

Figure 10a

Bracket

Rear Leg

“Curve”

Figure 10b

Holes

Leg

Extension

Assembly Guide