Owner manual

Assembly Guide

Figure 12

Figure 11

Step 11 - Attach the Rollers to the Leg

Extension

Locate the following items:

• From Step 10 - Main Assembly

• Item #14 - Foam Rollers

• Item #15 - Foam Roller End Caps

• Item #16 - Short Chrome Roller Tubes

• Item #17 - Long Chrome Roller Tube

• Item #18 - Roller Tube Spacers

There are (3) Chrome Roller Tubes on the Leg Extension. Place

the Long Chrome Roller Tube (Item #17) through the hole

closest to the Seat.

There are two holes possible in the Leg Extension Pivot Tube

for the lower of the Short Chrome Roller Tubes (Item #16).

Select the correct lower hole for your height - the Roller

should rest on your lower shin above the ankle. Insert the (3)

Chrome Roller Tubes through the holes on the Leg Extension

Pivot Tube and Rear Leg, as shown in Figure 11

Slide (2) Roller Tube Spacers (Item #18) over each end of the

Long Chrome Roller Tube. Then, slide (2) Foam Rollers (Item

#14) over the ends of all three tubes. Cap the Roller Tubes

with the (6) Foam Roller End Caps (Item #15).

Note: Use a Rubber Mallet to secure the End Caps.

Step 12 - Attach Leg Cable to the Leg

Extension

Locate the following items:

• From Step 11 - Main Assembly

• Item #AA - (1) Leg Cable

• Item #F - (1) 3/8" X 2 1/2" Button Head Screw

• Item #N - (2) 3/8" Washers

• Item #O - (1) 3/8" Nylock Nut

• Item #Q - (1) Bolt Cover

Slide the hooked end of the Leg Cable beneath the Leg

Extension Pulley and into the hole on the Leg Extension Pivot Tube,

as shown in Figure 12.

Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X 2

1/2" Button Head Screw (Item #F). Thread the screw through

holes in the Leg Extension and cable end. Place (1) 3/8"

Washer and (1) 3/8" Nylock Nut (Item #O) over the end of the

screw, as shown in Figure 12, and tighten.

Completely tighten hardware installed during

Step 12.

Place (1) Bolt Cover (Item #Q) over the Nylock Nut

installed during Step 12.