Owner manual

A-13

Assembly Guide

Step 16 - Attach the Upper Lat Tower to the

Lower

Locate the following items:

• From Step 15 - Upper Lat Tower Assembly

• F

rom Step 14 - Main Assembly

• Item #E - (6) 3/8" X 3/4" Button Head Screw

• Item #N - (6) 3/8" Washers

Carefully insert the end of the Upper Lat Tower into the open

end of the Lower Lat Tower. Align the holes on the Upper Lat

Tower with the holes on the Lower Lat Tower.

Place (6) 3/8" Washers (Item #N) over the ends of (6) 3/8" X

3/4" Button Head Screws (Item #E) - one washer per screw.

Thread the screws into the aligned holes, as shown in

Figure 16

Completely tighten hardware installed during

Step 16.

Step 17 - Attach the Rod Box with Power

Rod® Unit to the Rod Box Frame

Locate the following items:

• Item #24 - Rod Box Frame

• Item #25 - Rod Box with Power Rod® Unit

• Item #B - (3) #10 X 1" Phillips Head Screws

• Item #L - (3) 1/4" Washers

Place the Rod Box Frame (Item #24) and Rod Box with

Power Rod® unit (Item #25) onto one side as shown in

Figure 17. Slide the Rod Box with Power Rod® unit into

the Rod Box Frame until the Rod Box is completely seated

in the Rod Box Frame.

Place (3) 1/4" Washers (Item #L) over the ends of (3) #10 X 1"

Phillips Head Screws (Item #B) - one washer per screw.

Insert the screws through the slot on the Rod Box Frame and

thread into the holes in the Rod Box with Power Rod® unit.

Completely tighten hardware installed during

Step 17.

Figure 16

Upper Lat

Tower

Lower Lat

Tower

Figure 17

Slot