Owner manual

A-16

Step 22 - Attach the Bench to the Seat

Assembly

Locate the following items:

• Item #29 - Bench Pad

• F

rom Step 6 - Seat Assembly

The Bench easily attaches and releases from the Seat. To

attach the Bench, insert the half hinge on the end of the

Bench into the half hinge on the seat. To remove the Bench,

lift up on the long portion and pull away from Seat.

Steps 23 through 26 illustrate how to route and

connect the Cables to your new BowFlex

Elite™ Plus

home gym.

Step 23 - Route the Rod Cables

Locate the following items:

• Item #S - (2) Hand Grips

• Item #V - (2) Snap Hooks

• Item #Y - (2) Rod Cables with (2) Snap Hooks (attached)

Un-wrap the Cables from both Pulleys on the Chest bar. Pull

one end of the Cable from the Chest Pulley upwards. Attach

the Cable to one Rod Cap by hooking the Rod Hook through

the hole in the Rod Cap.

Then, fasten one Hand Grip to the Snap Hook on the opposite

end of the Cable, as shown in

Figure 23.

Repeat for remaining Chest Pulley Rod Cable.

Figure 22

Seat

Assembly

Note: At this time, carefully go over your entire

BowFlex

Elite™ Plus home gym, tightening

all screws, nuts and other hardware

securely before exercising on your BowFlex

Elite™ Plus home gym.

Figure 23 - Rod Cables

Hand

Grip

Snap

Hook

Rod

Hook

Rod

Cap

Assembly Guide