Owner manual

A-7
Step 8 - Attach the Rear Leg to the Seat Rail
Locate the following items:
• From Step 6 - Seat Rail Assembly
• From Step 7 - Rear Leg Assembly
• Item #J - (1) 3/8" X 4 1/4" Button Head Screw
• Item #N - (2) 3/8" Washers
• Item #O - (1) 3/8" Nylock Nut
• Item #Q - (2) Bolt Covers
Undo the twist ties from the Pivot Bushings on the end of the Rear
Leg Assembly (from Step 6), but do not remove the Bushings.
Note: When attaching the Rear Leg Assembly (from
Step 7) to the Seat Rail Assembly, rotate the Rear
Leg forward (as shown in Figure 8b), to allow the
Leg Latch to engage with the Seat Rail Pull Pin.
Align the holes on the End Bracket of the Seat Rail Assembly with
the middle holes on the Rear Leg Assembly, (see Figure 8).
Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X 4 1/4"
Button Head Screw (Item #J). Insert the screw through the lined
up holes and then loosely secure on the opposite side by placing (1)
3/8" Washer and (1) 3/8" Nylock Nut (Item #
O) over the end.
Do not over-tighten hardware from Step 8.
Note: Tighten the nylock nut enough that the threads
of the screw extend through the nylock nut, but loosely
enough that the Leg Assembly can move freely.
At this time, place (1) Bolt Cover (Item #Q) over the Nylock
Nut installed during Step 8, place 1 bolt cover over the
Nylock Nut going through the rear leg pulley.
Once you have completed Step 8, rotate the Rear Leg back until
it engages the Seat Rail Pull Pin.
Figure 8
J
O
Rear Leg
Assembly
Rail
Assembly
End
Bracket
Middle
Hole
N
Figure 8b
Rail
Assembly
Rear Leg
Seat Rail
Pull Pin
Leg Latch
Assembly Guide