Specifications

A-12
Figure 14
Leg Extension
Seat
Roller Tube
Spacers
Support Tube
Bracket Hooks
Back Edge
Step 14 - Attach the Leg Extension Seat to the Main
Assembly
Locate the following items:
• From Step 13 - Leg Extension Seat Assembly
• From Step 12 - Main Assembly
The Leg Extension Seat Assembly is removable, and can be
attached to the Rear Leg Assembly easily by placing the Rail
Bracket Hooks over the Rear Rollers.
Place the Rail Bracket Hooks onto the Roller Tube Spacers
(sandwiched between the Rear Leg and the Foam Rollers).
Once the Support Tube Bracket Hooks connect with the
Roller Tube Spacers, slightly “roll” the back edge of the Seat
down to lock into place.
Warning: For your safety, always ensure that the Support
Tube Bracket Hooks fully engage with the Roller Tube
Spacers.
To remove the Leg Extension Seat Assembly, reverse
this procedure.
Step 15 - Attach the Lat Cross Bar to the Upper
Lat Tower
Locate the following items:
• Item #22 - Lat Cross Bar - Do not unwrap cables!
• Item #23 - Upper Lat Tower
• Item #H - (2) 3/8" X 3" Button Head Screws
• Item #N - (4) 3/8" Washers
• Item #O - (2) 3/8" Nylock Nuts
Align the holes in the Lat Cross Bar (Item #22) with the
holes in the bracket on the Upper Lat Tower (Item #23).
Place (2) 3/8" Washers (Item #N) over the ends of
(2) 3/8" X 3" Button Head Screws (Item #H) - one washer
per screw. Thread the screws through the aligned holes,
then secure by placing (1) 3/8" Washer and (1) 3/8" Nylock
Nut (Item #
O) over each screw and tighten.
Completely tighten hardware installed during Step 15.
Assembly Guide
Figure 15
N
23
22
H
O
Lat
Tower
Bracket