Home Gym Assembly Instructions

A-9

Step 10 - Attach the Leg Extension Pivot Tube

Locate the following items:

• Item #13 - Leg Extension Pivot Tube

• From Step 9 - Main Assembly

• Item #30 - Lock Out Pin

• Item #G - (1) 3/8" X 2 3/4" Button Head Screw

• Item #N - (2) 3/8" Washers

• Item #O - (1) 3/8" Nylock Nut

• Item #Q - (1) Bolt Cover

Undo the twist ties from the Pivot Bushings. Align the holes

located on the “curve” of the Leg Extension Pivot Tube (Item #13)

with the holes on the bracket of the Rear Leg, as shown in Figure

10a.

Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8"

X 2 3/4" Button Head Screw (Item #G). Thread the

screw through the aligned holes and bushings and secure

by placing (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item

#O) over the end of the screw, as shown in Figure 10a.

Do not over-tighten hardware from Step 10.

Place (1) Bolt Cover (Item #Q) over the Nylock Nut

installed during Step 10.

Note: When storing the Rail Assembly, insert the Lock

Out Pin (Item #30) through the holes in the Pivot Tube to

temporarily hold the Leg Extension in place while folding the

Rail up (see Figure 10b).

Figure 10a

Bracket

Rear Leg

“Curve”

Figure 10b

Holes

Leg

Extension

Assembly Guide