Home Gym Assembly Instructions

A-13

Assembly Guide

Step 16 - Attach the Upper Lat Tower to the Lower

Locate the following items:

• From Step 15 - Upper Lat Tower Assembly

• From Step 14 - Main Assembly

• Item #E - (6) 3/8" X 3/4" Button Head Screw

• Item #N - (6) 3/8" Washers

Carefully insert the end of the Upper Lat Tower into the

open end of the Lower Lat Tower. Align the holes on the

Upper Lat Tower with the holes on the Lower Lat Tower.

Place (6) 3/8" Washers (Item #N) over the ends of (6) 3/8"

X 3/4" Button Head Screws (Item #E) - one washer per

screw. Thread the screws into the aligned holes, as shown in

Figure 16

Completely tighten hardware installed during Step 16.

Step 17 - Attach the Rod Box with Power Rods® to

the Rod Box Frame

Locate the following items:

• Item #24 - Rod Box Frame

• Item #25 - Rod Box with Power Rods®

• Item #B - (3) #10 X 1" Phillips Head Screws

• Item #L - (3) 1/4" Washers

Place the Rod Box Frame (Item #24) and Rod Box with

Power Rods® (Item #25) onto one side as shown in

Figure 17. Slide the Rod Box with Power Rods® into the

Rod Box Frame until the Rod Box is completely seated in

the Rod Box Frame.

Place (3) 1/4" Washers (Item #L) over the ends of (3) #10 X

1" Phillips Head Screws (Item #B) - one washer per screw.

Insert the screws through the slot on the Rod Box Frame

and thread into the holes in the Rod Box with Power

Rods

®.

Completely tighten hardware installed during Step 17.

Figure 16

Upper Lat

Tower

Lower Lat

Tower

Figure 17

Slot