Service manual

MECHANICAL SERVICE GUIDE

2.0 - REPLACEMENT OF CONSOLE WITH HANDLEBARS

Tools Needed:

• Phillips Screwdriver

• 1/2 inch wrench

• 3/16 inch Allen wrench

NOTE: If using a powered driver, it must be on the “LOW

TORQUE” setting, otherwise it will strip screws.

2-1 Unplug machine from outlet.

2-2 Wait 5-minutes after unplugging machine to ensure

there is no residual power.

2-3 TC5300 only:

Remove the right and left upper upright plastics by

removing 2 small screws from the inside of each

upright (see Figure 1 & 2).

2-4 Remove 4 button head bolts attaching console to

handlebars on both sides of machine (see Figure 3

& 4). NOTE: 3 bolts are located on the inside and 1

bolt is on the front side of the upright support.

2-5 With the help of another, carefully lift console out

and detach cable connector running through right

upright (see Figure 5 and 6).

2-6 Attach cable connector from new console to the

cable connector from the right upright.

Figure 1:

Figure 2: Upright Plastic Cover Removed

Figure 3:

AS LONG AS THE TREADCLIMBER® FITNESS

MACHINE IS PLUGGED INTO A POWERED OUTLET

AND THE POWER SWITCH IS ON, THE UNIT IS

RECEIVING POWER, EVEN IF THE DISPLAY IS

TURNED OFF. ALWAYS UNPLUG THE POWER CORD

FROM THE OUTLET AND WAIT 5-MINUTES BEFORE

PERFORMING REPAIRS OR MAINTENANCE.

7 ! 2 . ) . '

! 4 4 % . 4 ) / .

$ ! . ' % 2

)--%$)!4%!#4)/.2%15)2%$

# ! 5 4 ) / .

3 Bolts on inside of Upright Support

1 Bolt on front of Upright Support