Service manual

13.0 - REPLACEMENT OF LOCK-OUT LEVER

Tools Needed:

• Phillips Screwdriver

• 7/16 inch wrench

NOTE: If using a powered driver, it must be on the

“LOW TORQUE” setting, otherwise it will strip

screws.

13-1 Unplug machine from wall outlet and from front of unit.

13-2 Wait 5-minutes after unplugging machine to ensure

there is no residual power.

13-3 Remove the front base plastic (4 screws) see

Figure 1.

13-4 Remove the right and left top base plastic (3 screws

each) see Figure 1.

13-5 Loosen the setscrew with a Phillips screwdriver

and pull cable through the plastic junction. See

Figure 3.

13-6 Remove the old lockout lever by removing 7/16 inch

bolt and retaining spring. Remove the cable and

fine adjustment assembly from the old lever. See

Figure 2, 4 and 5.

MECHANICAL SERVICE GUIDE

Figure 1:

Figure 2: Unlock Treadles Position

Figure 3: Major Adjustment

AS LONG AS THE TREADCLIMBER

FITNESS

MACHINE IS PLUGGED INTO A POWERED OUTLET

AND THE POWER SWITCH IS ON, THE UNIT IS

RECEIVING POWER, EVEN IF THE DISPLAY IS

TURNED OFF. ALWAYS UNPLUG THE POWER CORD

FROM THE OUTLET AND WAIT 5-MINUTES BEFORE

PERFORMING REPAIRS OR MAINTENANCE.

7 ! 2 . ) . '

! 4 4 % . 4 ) / .

$ ! . ' % 2

)--%$)!4%!#4)/.2%15)2%$

# ! 5 4 ) / .

Right & Left Top Base

Plastic Covers

Front Base

Plastic Cover

Treadle Lockout Lever

Faceplate

Setscrew

Junction Plastic

Cable