TreadClmber Assembly Guide & Owner's Manual

ASSEMBLY GUIDE

ASSEMBLY PROCESS

Step 4: Installing Upright Covers

Locate the following for this step:

Parts:

• Assembly from Step 3

• Right Lower Upright Plastic Cover (Qty. 1) -

• Left Lower Upright Plastic Cover (Qty. 1)

Hardware:

• #8 Phillips Head Screw (Qty. 8)

Tools:

• Phillips Screw Driver

4-1 Unlock treadles.

4-2 Raise the right treadle to full height allowing for

access to the inside of the right upright support.

4-3 Align the Right Lower Plastic Cover to the Right

Upright Support by sliding the bosses into the

upright. Attach the Right Lower Upright Plastic

Cover to the Right Upright Support using two of

the #8 Phillips head screws from the inside of the

support.

4-4 Repeat process on left side.

Figure 4: Installing Upright Covers

Phillips Head Screws

Lower Upright Plastic Cover

Phillips Head Screws

Lower Upright

Plastic Cover