TreadClmber Assembly Guide & Owner's Manual

22
ASSEMBLY GUIDE
Step 9: Inspecting Final Assembly
Congratulations!
Now that you have assembled your Bowflex®
TreadClimber® fitness machine, it is VERY
IMPORTANT to tighten all screws and bolts, and
visually inspect the unit. If your TreadClimber®
fitness machine sits unevenly you may adjust
the rear feet with a wrench to make the exercise
machine stable on your floor. Make sure that your
TreadClimber® fitness machine has been assembled
correctly and securely, and that there are no loose or
unattached parts prior to using the machine.
Failure to visually check and test assembly
before use can cause damage to the Bowflex®
TreadClimber® fitness machine, serious injury to
users and bystanders, and can also compromise
the effectiveness of your exercise program.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
Step 8: Attaching Power Cord
Locate the following for this step:
Parts:
• Assembly from Step 7
• Power Cord
8-1 Locate the power cord.
8-2 Attach the power cord to the AC Inlet on the front
of the TreadClimber® fitness machine base frame.
NOTE: Wall outlet must be
a non-GFI protected circuit,
within reach of the power cord.
Figure 8: Attaching Power Cord
AC Inlet
ASSEMBLY PROCESS