TreadClmber Assembly Guide & Owner's Manual

CONDITION/PROBLEM THINGS TO CHECK SOLUTION

Electronics If all I/O cables are functioning properly, LED D indicates

speed sensor is functioning, and err LS or OS persists

problem is in either the upper electronics board or the

motor controller board. With machine on check LED A

on the controller board. If it is dimly lit replace upper

electronics (000-4430). If it is not lit at all replace motor

controller.

Floors Climbed Display not

updating.

Size of steps taken In order for a step to register, the pedals must pass each

other completely. This ensures that the magnet on the

Step passes the step sensor. Make sure treadles are not

locked in treadmill mode and that they are moving enough

to register a step.

STEP SENSOR

1. Cycle power off and on.

2. Put the machine in calibration mode (see Calibration

procedures, Pg. 26) but do not start the calibration routine.

3. Remove right rear base plastic cover to allow access to

LED board. Caution: Machine is on. Current is active!!

4. Locate LED C on the motor controller board. LED may

be lit or unlit.

5. Manually manipulate the treadles up and down and

check if LED C is blinking.

6. If LED C is not blinking, then the step sensor is

not supplying a signal. Check that the step sensor is

connected securely to P2 on the motor controller. If sensor

is connected and LED C still does not flash replace sensor.

I/O CABLES

If LED C is flashing when the treadles are moved but

steps are still not being counted check for signs of visible

damage and connections to any of the three I/O calbes. If

no visible damage check continuity using a multi-meter. If

a multi-meter is not available replace all three cables.

TROUBLE SHOOTING GUIDE

REPAIRS/MAINTANENCE