Owner`s manual

Walking Belt Electrostatic Reduction

Your TreadClimber

machine may develop a static charge caused by the movement of the walking belts. Follow this

procedure to apply an anti-static spray to them to reduce the static electric charges.

Wait a minimum of 60 minutes after the last workout before you apply the anti-static spray, to let hot electrical

components cool to room temperature.

1. Unplug the machine from the wall.

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the

power cord from the wall outlet and/or the machine and wait 5 minutes before cleaning, maintaining or repairing the

machine. Place the power cord in a secure location.

2. Using a 5 mm hex wrench, loosen the tension adjustment bolts for the walking belts to let them slide easily. Turn

the bolts counterclockwise to decrease the tension.

Note: Be sure to record how many turns it takes to loosen the bolts to assist with reassembly.

3. Carefully apply the anti-static spray to lightly cover the

top surface of the walking belts along the front of the

machine, farthest from the motor (green highlighted area).

NOTICE: Hold the spray dispenser approximately 6” (13 cm)

above the walking belt and point the spray toward the front

of the machine, away from the motor. Apply the spray only

on the belts, not on the deck or mechanism. If spray goes

off the belts, wipe the excess spray off the other parts of the

machine.

Note: Be sure to obey the manufacturer safety

instructions for the anti-static product.

4. Using your foot, manually advance the walking belts

toward the back of the machine, exposing the next

unsprayed section.

5. Do steps 3 and 4 again until all sections of the belts are

lightly coated with anti-static spray.

Maintenance

Be sure to record how many turns it takes to loosen the bolts to assist with reassembly.