INSTRUCTIONS FOR USE Pro-Ject Vinyl NRS Box S3
Dear music lover, thank you for purchasing this Pro-Ject Audio Systems´ product. In order to achieve maximum performance and reliability you should study these instructions for use carefully. Warning of a hazard for the user, the unit or possible misuse. Important notice. Safety instructions AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.
Front panel controls To switch on from standby or to standby The push button on the left side of the front panel turns the unit on or back into standby/bypass mode. The blue LED beside the stand-by push button shows that the unit is switched on. It takes approximately 3 seconds to activate the electronics until it goes into operational mode.
-6dB If the input level is too high, clipping can occur. In this case, the red clip LED located right beside the -6dB switch blinks and indicates a system overload. In such a situation, please reduce the gain of your phono preamplifier. If your preamplifier does not have a gain setting, press the -6dB button on your Vinyl NRS Box S3. Clipping should no longer occur. Note that this reduction does not affect the bypass mode! Bypass mode will be 6 dB louder than operational (ON) mode in this case.
