Instruction manual
Table Of Contents
- Heading1 - Table of Contents
- Heading1 - Safety Instructions
- Heading1 - Introduction
- Heading1 - Setting up the Projector
- Heading2 - Connecting the CablePro™III to the Projector
- Heading2 - Preparing to Connect Your Equipment to the Projector
- Heading2 - Connecting a Laptop Computer
- Heading2 - Connecting a Desktop Computer
- Heading2 - Connecting a Computer Using a VESA cable
- Heading2 - Connecting a Video Player
- Heading2 - Connecting an External Speaker
- Heading2 - Powering up the Projector and Adjusting the Image
- Heading2 - Turning Off the Projector
- Heading1 - Using the Projector
- Heading2 - Basic Image Adjustment
- Heading2 - Using the Remote Control
- Heading2 - Adjusting the Projector
- Heading2 - Using the Remote and Keypad Buttons
- Heading2 - Using the On-Screen Menus
- Heading2 - Display Menu Functions
- Heading2 - Audio Menu Functions
- Heading2 - Image Menu Functions
- Heading2 - Controls Menu Functions
- Heading2 - Language menu
- Heading2 - Status menu
- Heading1 - Maintenance & Troubleshooting
- Heading1 - Appendix
- Heading1 - Index
32
Using the Projector
Rear Projection
When you select
Rear Projection
, the projector reverses the image
so you can project from behind a translucent screen.
Default Source
Default Source toggles between Computer and Video. This deter-
mines which source the projector checks first for active video
during power-up. Click the button to toggle between the options.
Auto Source Select
This setting toggles between On and Off. When this feature is Off,
the projector defaults to the source selected in Default Source. To
display another source, you must manually select one by press-
ing the
computer
or
video
button on the keypad or remote. When
this feature is On, the projector automatically finds the active
source, checking the default source first. Click the button to tog-
gle between the options.
Plug and Play
This setting toggles between On and Off. When it is On, most
new computers will automatically recognize the projector, then
set the monitor resolution and refresh rate accordingly. You need
to set the Plug and Play setting to Off for the projector to display
properly on some older computers. The Plug and Play setting
does not affect video images.
If the projector display constantly changes between the computer
image and the message, "Perfecting the image", you may need to
set Plug and Play to Off.
Display Messages
This setting toggles between On and Off. When this feature is On,
status messages such as “No signal detected” and “Standby”
appear in the lower-right corner of the screen. Click the either
mouse button to turn this feature off and not see status messages.
Downloaded From projector-manual.com Boxlight Manuals