Use and Care Manual

H
9
C
D
C
C
5
9
H
B D
1
C
12
4x
C
8x
11
6
H
F
10
4x
12
10
Attach the eight 20mm bolts(Part 1) to the headboard leg(Part B)and
footboard(Part D) using the large hex key(Part 12). Do not tighten.
Attach four center leg(Part F) to the slats(Part H) using
40mm bolt(Part 6). Tighten the bolt using small hex
key(Part 11). Repeat the step for all four support leg.
Attach the adjuster leg(Part 10) to the center leg
(Part F). Make any adjustment necessary to ensure
the legs are touching the floor.
Attach the complete side rail to headboard(Part A) and footboard
(Part D) by sliding the side rail brackets onto the bolts on the
headboard legs(Part B) and footboard(Part D). Do not tighten yet.
Place the four slats into the bed as shown. Tighten the bolts
on the headboard legs and footboard using large hex key
(Part 12). Secure the 4 slats using eight screws(Part 9) and a
Phillips Screwdriver. Your bed is now set up and ready for
use.
F
A