Warranty

011/012

SEAT INSTALLATION

CARE AND CLEANING

Your new toilet is made of stain-, acid- and abrasion-

resistant vitreous china. Clean the outside surface with mild

soap, warm water and a soft cloth. On stubborn stains use a

powdered detergent and damp sponge or nylon scouring

pad. Never use abrasive scouring powders, cleansers or

pads because they will scratch, damage and dull the

surface. The manufacturer shall not be responsible or liable

for any tank tting damage caused by the use of cleaners

containing chlorine (calcium hypochlorite). When cleaning

your toilet seat, wash it with mild soapy water. Rinse the

seat thoroughly with clean water and dry with a soft cloth.

Avoid detergents, disinfectants or cleaning products in

aerosol cans. NEVER use abrasive scouring powders on

your seat. Some bathroom chemicals and cosmetics may

cause damage to the seat’s nish, so test your cleaning

solution on an inconspicuous area before applying to the

entire surface.

Remove the seat and cover from it’s box. Insert the top

fixing rawl plugs into the seat bolt holes. Place the hinge

blocks, without the stainless steel covers, over the rawl

plugs and loosely fix the screw though the hinge blocks

into the rawl plugs(step 1 and step 2). Fit the seat and

cover onto the hinge blocks by locating the fixing holes

onto the hinge pins and push into place. Close the seat and

cover onto the pan, and adjust the position in line with the

rim of pan. Tighten the screws. Open the seat and cover

and depress the quick fix buttons to remove the seat and

cover. Place the stainless steel covers over the hinge

blocks(step 3) and replace the seat.

step 1

step 2

step 3

WARNING: DO NOT USE IN-TANK CLEANERS.

Products containing chlorine (calcium hypochlorite) can

seriously damage tank ttings potentially causing leaks,

excessive water use and property damage.