Specification

IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a
combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the
supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in
the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product
acceptance by Authorities Having Jurisdiction.
This listing period is based upon the last date of the month indicated on the Effective Date and Void After Date shown above. Any change in material,
manufacturing process, marking or design without having first obtained the approval of the Product Certification Committee, or any evidence of
non-compliance with applicable codes and standards or of inferior workmanship, may be deemed sufficient cause for revocation of this listing.
Production of or reference to this form for advertising purposes may be made only by specific written permission of IAPMO Research and Testing, Inc.
Any alteration of this certificate could be grounds for revocation of the listing. This document shall be reproduced in its entirety.
The most updated information on this Certificate of Listing is available online at pld.iapmo.org
Effective Date: November 2018 Void After: November 2019
Product: Plumbing Fixture Fittings File No. 10633
Issued To: Aqua Gallery Co.,ltd
13th-15th A10 Block
International Ceramics&
Sanitary City, 528000
Foshan,
China
Identification: Plumbing supply fittings complying with this Standard shall be marked
with the manufacturer's recognized name, trademark, or other mark or,
in the case of private labeling, the name, trademark or other mark of
the customer for whom the fitting was manufactured. The marking shall
be accomplished by use of a permanent mark or by placing a permanent
label on the product. Markings on plumbing supply fittings shall be
visible after installation.
Single-handle, single-control, and automatic compensating mixing bath
and shower valves shall have identifiable temperature control settings
in which the settings are indicated by words ("cold", "warm", "hot",
etc.), by numbers, or graphically.
Packages shall be marked with the manufacturer's name, trademark, or
other mark as well as the model number or, in the case of private
labeling, the name, trademark, or mark of the customer for whom the