LORDEAR www.lordear.
Stainless Steel Kitchen Sink Premium grade handmade sink 16 gauge Stainless Steel 304 Vertical angle corner/R10 radius coved corner Best-in-breed sound and thermal insulation Limited lifetime warranty In Accordance with Industry Codes & Standards for USA & Canada All LORDEAR Stainless Kitchen Sinks are Certified & Listed By cUPC. CAUTION Due to the weight and sharp edges of the sink, exercise caution when handling, moving or lifting the box or the sink.
TOOLS Safety glasses / maker / silicone adhesive sealant / tape measure / Jigsaw / rags / wood braces / level / screws / bladed screwdriver Step 1 : Position Template Check the cut-out template against the actual sink to ensure a proper sized cut-out， then Place the cut-out template in the desired location on the countertop Step 2 : Trace Template Trace template on countertop with a pencil (Figure 1) Step 3 : Cut Countertop Cut the opening in the countertop by carefully following the traced line (Not
Step 4 : Attach the mounting hardware to the prongs protuding from the underside of the sink rim. Make sure the hooked side of the mounting clip is facing away from the sink. Step 5 : Apply Silicone or Plumber's Butty Clean and dry the surface around the opening of the sink; Turn the unit upside down to apply sealant (not included) underneath of the sink rim.
Step 7 : Install Plumbing Fixtures • Connect drain to sink. Connect trap to drain.
MAINTENANCE INSTRUCTIONS FAQs 1. Why is there rust in my new kitchen sink? Reasons: 1.1 The rust may be caused by the welding cement, or oil residue on the sink which when not cleaned on time can lead the sink to rust. 1.2 Chemical cleaning agent, paint, sauces or cooking oil left in the kitchen sink after a certain period of time these will create molds and the molds would stick on the surface. Prevention and Treatments: 1.
DO 1. Clean Daily. Use a soft towel to wipe the sink with warm water. Mixing in some wash-er-fluid is advisable. Remember to wipe it dry. 2. Remember to rinse the sink after using any cleaning agent and wipe dry. If any mineral deposits built up on the sink, clean up it as soon as possible. 3. Properly remove the rust, molds or scratches with a scouring pad. Rubbing the sink in the direction of the grain. 4. Rub it lightly with a soft towel in the direction of grain lines. 5.
STAINLESS STEEL KITCHEN SINKS General Recommendations: Check all the matching products inside when opening the package. Inspect your sink for any noticeable damage before installation. Read the installation and maintenance instruction thoroughly before installation. Consult your cabinet dealer before custom order cabinet for the sink. LORDEAR suggests using experienced and professional installers.
