Installation Guide

7
/
8
DO
1. Clean Daily. Use a soft towel to wipe the sink with warm water. Mixing in some wash-er-fluid is advisable.
Remember to wipe it dry.
2.
Remember to rinse the sink after using any cleaning agent and wipe dry. If any mineral deposits built up on
the sink, clean up it as soon as possible.
3.
Properly remove the rust, molds or scratches with a scouring pad. Rubbing the sink in the direction of the
grain.
4.
Rub it lightly with a soft towel in the direction of grain lines.
5.
Keep the sink dry after you use it. Because any standing water can cause a buildup of mineral deposit,
which will become hard water stains.
DO NOT
1. Leave water spots, utensils or steel cool-ware in the sink for a long time, which would become rust spots in
your sink surface.
2. Leave cleaning agents or bleach sitting in your sink for a long period of time which may cause the sink to
discolor or damage the surface.
3. Use a steel wool or scouring pad rubbing against the direction of the grain.
4. Leave rubber mats, cleaning pads or sponges in the sink for a long time as this may ruin the finish of your
sink.
How to use scouring pad correctly?
5. Use the inside of the sink as cutting surface.
1. Get a dry and clean non- scratch scrub pad.
2. Scrub the rust off according to the direction of the grain.