INSTRUCTION MANUAL WINE CELLAR MODEL: JC-58A/JC-85B / JC-145B/JC-115 This manual contains important information including safety and installation instructions of the appliances. Please read it carefully before use and follow all safety information & instructions. It is recommended to keep this manual for easy reference so that you can be familiar with the operation of the appliance.
CONTENTS WARNING----------------------------------------------------------------------------------------------------------2 IMPORTANT SAFETY INSTRUCTIONS-------------------------------------------------------------------3 UNPACKING AND INSTALL THE DOOR HANDLE-----------------------------------------------------4 INSTALLATION INSTRUCTIONS ---------------------------------------------------------------------------4 TEMPERATURE SETTING----------------------------------------------------------------------------
self-checking before operation. IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions: WARNING Read all instructions before using the Wine cellar. DANGER or WARNING: Risk of child entrapment. Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous even if they will “just sit in the garage a few days”.
UNPACKING AND INSTALL THE DOOR HANDLE Remove the exterior and interior packing materials. Install the door handle provided with the appliance by following these steps: Step 1 －Remove the gasket at the inner side of the door to expose the two screw holes. G asket Step 2 －Install the handle tightly with the screws and washers provided. Step 3 －Tidy and restore the gasket.
Should the Wine cellar be stored without use for long periods, it is suggested to leave the door ajar to allow air to circulate inside the cabinet after a careful cleaning, avoiding possible formations of condensation, mold or odors. Ambient Room Temperature Limits This appliance is designed to operate in ambient temperatures specified by its temperature class marked on the rating plate. Class Symbol Ambient Temperatures range (℃ / ℉) Extended Temperate SN ﹢10℃/ 50 ℉ to﹢32℃ / 89.
Storage of Model JC-58A ●Shelf One To Five - 3 Bottles Per Shelf ●Bottom Section - 4 Bottles - Storage of Model JC-85B ●Shelf One To Five - 5 Bottles Per Shelf ●Bottom Section - 3 Bottles 6
Storage of Model JC-145B ●Shelf One To Five - 8 Bottles Per Shelf ●Bottom Section - 6 Bottles Storage of Model JC-115 Red wine region ●Shelf One To Five - 3 Bottles Per Shelf ●Bottom Section - 4 Bottles Beverage area ●Shelf One -9 Bottles ●Shelf Two to Three- 18 Bottles Per Shelf ●Bottom - 12 Bottles TEMPERATURE SETTING WINE STORAGE ● To prevent damaging the door gasket, make sure to have the door opened fully all the way before pulling the shelves out. ● Please store wine in sealed bottles.
forming. ● Recommended Temperatures for chilling/storage your wines. Red Wines 15-18ºC / 59-64.4℉ Dry/White Wines 9-14ºC / 48.2-57.2℉ Rose Wines 10-11ºC / 50-51.8℉ Sparkling Wines 5-8ºC / 41-46.4℉ OPERATING YOUR WINE CELLAR AND SETTING THE TEMPERATURE CONTROL FOR JC-58A/JC-85A/JC145A WINE CELLAR Control System Instruction Power switch button ;Press : Plug in, press for 3 seconds to turn on or off the unit. to change the temperature display between Celsius and Fahrenheit.
Power switch Left combination button ;Press and at the same time for 3 seconds to change the temperature display between Celsius and Fahrenheit. Left display window show the temperature of lower zone, the temperature will increase 1ºF : Plug in, press or 1ºC if you push the left for 3 seconds to turn on or off the unit. button , the temperature will decrease 1ºF or 1ºC if you push the left button.
upper or lower compartment automatically. The LED display will flash and show the setting temperature. After 5 seconds the flash will stop and it will show the actual measured interior temperature. Press the button “+” or ”-” once, the temperature will decrease or increase 1 ℃/1℉ After stopping pressing the button for 5 seconds, LED figure will stop flash, then revert back to display the setting temperature of the upper or lower compartment.
If need to take out any shelf which has the sliding rail, use one hand to press down the right plastic notch as shown in Figure A and at the same time lift the left plastic notch by other hand as shown in Figure B. Hold both notches and then proceed to pull out the shelf slowly. Contact our service department if assistance is needed.
Remark: The above picture is for reference only. Please refer to the actual product.
JC-145B, JC-115 13
LOCK & UNLOCK THE DOOR (FOR OPTION) Lock is an optional function. If your Wine Cellar has such function, a key should be attached inside the packing of this Manual. Insert the key into the lock and turn it counter-clockwise to unlock the door. To lock it, please follow the reversed operation. Please save the key well. CHARCOAL FILTRATION SYSTEM Your wine is a living object that breathes through the cork of its bottle.
Vacation Time Short vacations: Leave the Wine Cellar operating during vacations of less than three weeks. If the appliance will not be used for several months, remove all items and turn off the appliance. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the door open slightly: blocking it open if necessary. Moving your Wine Cellar: Remove all items. Take out the loose items inside the wine cellar (such as shelf), or fix the loose items with the foam.
Vibrations Too much noise The door will not close properly The control panel does not work The circuit breaker tripped or a blown fuse. The bulb has burned out. The light button is “OFF” Check to sure that the Wine Cellar is level. The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling. Contraction and expansion of the inside walls may cause popping and crackling noises. The Wine Cellar is not level. The Wine Cellar is not level.
