IMPORTANT INSTRUCTIONS & OPERATING MANUAL WARNING Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could result in fire, electric shock, or serious personal injury. CAUTION Keep this owner’s manual for future reference. If you sell or give this product away, make sure this manual accompanies this product.
IMPORTANT: It is important to read these instructions carefully before using the appliance for the first time. Keep the instructions safe so that you can refer to them later if necessary. IMPORTANT INSTRUCTIONS 【IMPORTANT INSTRUCTIONS】 When using electrical appliances basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1) Read all instructions before using this heater. 2) This heater is hot when in use.
UNPACKING AND TESTING APPLIANCE Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance operates properly by plugging the power supply cord into a conveniently located 110-120 Volt grounded outlet. Grounding Appliance Appliance】 【Grounding This appliance is for use on 120 Volts.For connecting three-blade grounding type plugs to three -slot receptacles.
Before installing the in-wall fireplace,please read the following steps carefully. Remove the two silver colored screws at both sides of the fireplace(See Step 1) Step 1 Lift glass panel and pull it out upwards to you,leave screws out when installing in wall.(See Step 2) Step 2 Removed log from the holes on both sides of electric fireplace with silver colored screws.(See Step 3) Left side Right side Put in optional fire crystals or log.
Warning Warning This carton includes GLASS!ALWAYS use extrme caution when handing glass. Failure to do so could result in personal injury or property damage. ALWAYS unplug this fireplace heater before assembly or cleaning, or before relocating. injury.
Plug the power cord into a 110-120 Volt 15 Amp outlet.Make sure the outlet is in good condition and that the plug is not loose.NEVER exceed the maximum amperage for the circuit.DO NOT plug other appliances into the same circuit. 】 【Special characteristics of this Electric Fireplace Fireplace】 1、The smouldering glow of the flames can hardly be distinguished from that of a real fireplace. 2、Produces the effect of a hot current of air. 3、Automatic and constant temperature control.
】 【Safety instructions instructions】 Only use the appliance in accordance with the instructions in this manual! It cannot be used for any other purpose. Never operate the appliance when the appliance itself or the main cable show any signs of damage. In order to avoid overheating, do not cover the heater. Be responsible when handling the packing material. Warning: plastic wrapping may be lethal to children. Do not place the appliance next to a socket.
】 【Instruction for Remote Controller and Switch Panel Panel】 Control Panel / Remote Control Operation (Control panel POWER switch must be ON to use remote control.) The touch display panel is shown by LED's on the front bottom right of the appliance. The LED's will appear on the bottom of the fireplace control panel. POWER FLAME Turns the appliance ON/OFF. Controls Flame brightness. 5 Settings: ( L1-L2-L3-L4-L5) Flame dims from L1 to L5. F5 is the brightest setting.
NOTICE When the heater is first turned on, a slight odor may be present. This is normal and should not occur again unless the heater is not used for a long period of time. NOTICE To improve operation, aim the remote control at the front of the fireplace. DO NOT press the buttons too quickly. Give the unit time to respond to each command. Remote Control Battery Information This remote control uses two AAA batteries (Not included).
CAUTION: sharp edges! 1. After installation, the power plug should be accessible. 2. If the power cord is damaged. It must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. 3. The heater must not be located immediately below a socket. 4. The appliance is not intended for use by young children or infirm persons. Young children should be supervised to ensure that they do not play with the appliance. 5.
