Instructions / Assembly

ASSEMBLY INSTRUCTIONS

READ & SAVE BELOW INSTRUCTIONS BEFORE ASSEMBLY

1. PLEASE SEPARATE AND IDENTIFY ALL PARTS,MAKING SURE THAT YOU HAVE ALL OF THE PARTS LISTED.

2. TO AVOID ANY SCRATCH DURING ASSEMBLY, PLEASE ASSEMBLE ON A SOFT MAT OR SIMILAR.

3. PLEASE ASSEMBLE STEP BY STEP AND FOLLOW THE INSTRUCTIONS.

4. WASHERS MUST BE USED.

5. WHILE EACH SCREW AND NUT IS PROPERLY FASTENED, DO NOT OVER FASTEN IT.

6. DO NOT COMPLETELY FASTEN EACH SCREW AND NUT UNTIL ALL THE SCREWS ARE PROPERLY FIXED.

GAZEBO

90MIN

PAGE 1
GAZEBO ASSEMBLY INSTRUCTIONS x3 90MIN READ & SAVE BELOW INSTRUCTIONS BEFORE ASSEMBLY 1. PLEASE SEPARATE AND IDENTIFY ALL PARTS,MAKING SURE THAT YOU HAVE ALL OF THE PARTS LISTED. 2. TO AVOID ANY SCRATCH DURING ASSEMBLY, PLEASE ASSEMBLE ON A SOFT MAT OR SIMILAR. 3. PLEASE ASSEMBLE STEP BY STEP AND FOLLOW THE INSTRUCTIONS. 4. WASHERS MUST BE USED. 5. WHILE EACH SCREW AND NUT IS PROPERLY FASTENED, DO NOT OVER FASTEN IT. 6. DO NOT COMPLETELY FASTEN EACH SCREW AND NUT UNTIL ALL THE SCREWS ARE PROPERLY FIXED.
PAGE 2
1 x4 2 x2 3 x2 4 x2 5 x2 7 x4 6 x6 9 x2 8 x4 M6x16 M6x42 Ax90 Bx16 Gx4 Hx8 M6x30 Cx8 Ix8 Dx12 Fx4 Ex4 Jx4 Kx2 Mx104 x1 x1 Nx1 Ox1 Px4 Install all the relevant screws,but do not tighten them completely at the very beginning. Tighten the screws fully one by one. Qx4 Don't tighten up the screw before you start next mounting during the installation.
PAGE 3
1 2 3
PAGE 4
3 4
PAGE 5
4 5 5
PAGE 6
6
PAGE 7
8 7
PAGE 8
9 8
PAGE 9
CARE AND CLEANING: 1. TO CLEAN,WIPE WITH DAMP CLOTH.DO NOT USE BLEACH,ACID SOLVENTS OR ABRASIVE CLEANERS OR FRAME PARTS. 2. DURING VARYING WEATHER CONDITIONS AND WINTER PERIOD,WE STRONGLY RECOMMEND THAT IT CAN BE STORED IN A DRY AREA WITH A SUITABLE COVER BEFORE STORAGE,PLS INSURE IT IS CLEAN AND DRY. 3. IN THE EVENT OF BARE METAL SHOWING DUE TO SCRATCH,IT IS PREFERRED TO TREAT WITH A RUST REPELLING VARNISH OR SIMILAR. 4. PERIODICALLY CHECK AND ENSURE THAT ALL THE SCREWS ARE COMPLETELY TIGHTEN. 5.