Installation manual

SAVIO PLUS COMBI MANUAL 27
Electrical Connections/Wiring12.
Figure 12.1
Removing Front Panel:
Remove the front panel by •
removing screws A and slid-
ing the front panel up and
away from the boiler
Removing Side Panel:
Remove screws B•
Figure 12.2
Removing Service Panel:
Remove screws C. •
Figure 12.3
Move the lower part of the •
side panels (fi gure 12.3).
Pull the control panel. When •
completely pulled out, the
panel can rotate 45° down-
ward.
Figure 12.4
Loosen screws D and remove •
the service panel (Fig. 12.4)
A
A
B
B
C
C
B
B
D
D
D
Power Connection:12.1
For the electrical connection to the boiler use electric wires which conform to local regulations.The
boiler, when installed ,must be electricallybonded to ground in accordance with the requirements
of the authority having jurisdiction or, in the absence of such requirements,with the National Elec-
trical Code,ANSI/NFPA 70 and/or Canadian Electrical Code Part I CSA C22.1, Electrical Code.
Aux États-Unis, garder un espace d’au moins 4 pieds horizontalement du terminal d’évacuation
aux compteurs du gaz, compteurs de l’électricité, régulateurs et équipement d’évacuation. Au
Canada, garder un espace de 6ft entre le terminal d’évacuation et ces dispositifs.
Connection to the electricity supply:12.2
Connect the electrical supply cable coming from the fused spur isolation switch to the power supply •
terminal block of the boiler (as shown in fi gure 12.5) keeping the same connections for the live wire
and the neutral wire.
12
L
N
3
To fused spur
isolation switch
Power supply
terminal block
External controls
terminal block
120 VAC
15 AMP BREAKER
Service Man's Switch
Fire - O - Matic
Figure 12.5
WARNING
Note: Do not connect live wires to
thermostat terminals 1-3.