Instruction manual

Upper Keyboard Model

Connect the two flat cables together between the tower and the display base.

Install four screws on both sides of the display base to lock the tower in place.

Install Platter

Take out the platter and put on to the scale.

Power On

Note: If unit has been stored or transported in below freezing temperatures, allow the

unit to warm up to room temperature before turning on AC power.

Remove the power cord from the package box. Install the power cord in the

recepticle on the bottom of the scale. Connect the power cord to AC power. Set the

power switch to the ON position. Allow at least 30 minutes warm-up time before

initial calibration.