Instruction manual

22
Label Installation
Open the plastic door on the right side of the scale.
Slide out the printer.
Press the trigger to open the printer head.
Install the labels according to the instruction legend on the printer frame.
Pull out the take-up spool Insert the liner into the spool slot. Push back the
spool.
Secure the liner on the take-up spool by spinning the spool clockwise.
Close the printer head gently, until it clicks.
Slide the printer into the scale. Close the plastic door.
Press the ` key to bring the label into the start position.
Note: Please refer to section 3 ‘Label Format’ to set the proper label format.