Instruction manual

73
No further transaction has been recorded.
DISCOUNT IMPOSS
This PLU does not allow to be discounted. Check the PLU Discount configuration,
or this PLU is in special offer.
TARE TOO BIG
The entered tare is too big.
PLU TARE ACTIVE
You are forbidden to override the PLU tare.
NO STABLE WEIGHT
The weight is not stable.
PUT PLATTER ON
The weight is too small and out of power up zero range.
ZERO NOT CAPTURE
The weight is too big and out of power up zero range.
WEIGHT TOO SMALL
The weight is too small to be printed.
ERROR TAKE-SENS
The take label sensor is not working properly.
ERROR POS_SENS
The gap sensor is not working properly.
ERROR INTERFACE
The serial port is not working properly.
Error Message
Listed below are the possible error codes. When an error code appears,
the scale should be switched off and on. In many cases the error will
disappear.
There are 3 different kinds of error messages:
Error Status 1:
Warning! After the warning the scale can still be used.
Error Status 2:
Press "CODE" key. Change to one of the CODE menu. Back to normal
operation mode.
Error Status 3:
Press "CODE" key and enter SERVICE MODE, after returning to normal
operation mode the scale will perform RESET.