User's Manual

WIRING SCHEMATIC
NOTE: The 0V or GND reference cable shall be included within the controller cable.
The 12Vdc power cable shall NOT be included in the controller Cable.
REGULATORY INFORMATION
CE Mark
The BT817 has passed all relevant tests and obtained CE approval.
C Tick
The BT817 has passed all relevant requirements for application of C Tick.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressively approved by BQT Solutions could void the user's authority to operate this equipment.
Designed & Manufactured
in
Australia
RED +12Vdc
BLACK GND
YELLOW/W* 485A
GREEN/W* 485B
YELLOW BUZ
ORANGE LED
GREEN W0
WHITE W1
BROWN/W* T1
BROWN/W* T2
GND
BUZ
LED
W0
W1
Reader
Connection
Power
Supply
Controller
+12Vdc
0V
Power Cable
Controller Cable
NOTE: If used with a shielded cable,
the shield is connected to Building GND.
* Tamper & RS485 cable connections are optional.
INTRODUCTION
Thank you for purchasing the BT817 Mifare
®
Contactless Smart Card Access Reader with KeyPad.
The BT817 is used in security applications and interfaces into Wiegand applications.
The BT817 is preset with specific 'Keys'. Valid smart cards are issued with the same 'Keys'. This ensures that the
system cannot be compromised.
The reader incorporates a LED to provide feedback to a person wishing to enter. The LED is controlled by the security
system.
The BT817 is low profile and can be installed in new installations or as an upgraded reader in existing proximity
access control systems.
INSTALLATION
Remove the cover by holding the unit by the rim and pushing the reader out with your thumbs.
GHI
4
PRS
7
#
*
M
NO
6
W
XY
9
DEF
3
- 1 -
- 10 -