Installation Manual

238
-
44710
-
00 REV 1/04
NSF CONSTRUCTION
COMMERCIAL ELECTRIC WATER HEATER
INSTALLATION INSTRUCTIONS
THE MANUFACTURER OF THIS WATER HEATER WILL NOT BE LIABLE FOR ANY DAMAGE RESULTING FROM
FAILURE TO COMPLY WITH THESE INSTRUCTIONS. READ THESE INSTRUCTIONS THOROUGHLY BEFORE
STARTING.
Before proceeding with installation of this NSF kit, please assure that this water heater has been installed in
accordance with local codes and/or ordinances. In the absence of local codes, this water heater must be
installed in accordance with the National Electric Code – latest edition. Refer to Installation instructions provided
with this water heater.
Assure the correct NSF kit for this water heater has been provided.
NSF Kit Required
Gallon
Size
NSF Kit Part No.
50 265-44542-01
80 265-44542-02
120 265-44542-03
Tools and Materials Required:
RTV sealant (provided)
Control box seal (provided)
Two (2) sheet metal screws (provided)
NSF label (provided) attached to these instructions
Caulk gun
¼” nut driver and/or drive tool
Installation Procedure:
1. Place control box seal on top of control box sealing
gap between control box and water heater jacket.
Attach control box seal to control box using two (2)
sheet metal screws (see Figure 1).
2. Seal water heater to floor using RTV sealant. Be
sure to seal water heater completely to floor without
leaving voids (see Figure 2).
3. Place NSF label on or adjacent to rating plate.
Figure 1
Figure 2
For safety and convenience, the NSF construction components must
be installed and serviced by a qualified technician.
INTERNET VERSION FOR REFERENCE ONLY