Installation / Operation Instruction Manual

02/04/2021 12 BI810
Software Setup
Understanding System Setup and Configuration
The display and configuration section of the display allows for system setup and calibration.
NOTES:
All changes made to the system will happen immediately. It is best not to make changes while the Boiler
is actively operating (active heat call). Satisfy thermostat call before entering the setup up section of the
display.
General Layout and Navigation
The next section will overview the various sections embedded within the SETUP / FAULT section of the
product display. Deeper in the manual, we’ll discuss the options imbedded within these setting in more
detail. Below is meant to be a brief overview with the goal of introducing you to the various buttons and
general navigation of the display.
Saving your Changes
The display uses the “BACK” and “HOME” buttons to compare changes and prompt you to save your
changes.
Let’s run through an example.
We’re going to set the boiler up as a multi-boiler system designating this boiler as the “LEAD”