Installation / Operation Instruction Manual

Page 33
Brute LX
SECTION 8.
Control Setup and Operation
The Brute LX control is an integrated electronic control
that includes ame control, safety device monitoring
and pump regulating functions. The control regulates
the heat input by controlling the blower speed and
activating the gas valve. The board controls the ignition
sequencing and monitors signals received by all boiler
sensors. The control regulates the boiler set temperatures
and operating modes. For typical heating and DHW
operation, the control is programmed to give priority to
domestic hot water. The control is setup using the User
Interface which contains 5 buttons and a digital display.
Figure 25. The User Interface
The User Interface is located on the one panel of
the Brute LX that is not removable. It contains all the
buttons and gauges that are necessary to contol and
monitor the unit. See Figure 25
8.1 Digital Display
The centerpiece of the User Interface is the Digital
Display. All of the needed parameters of the Brute LX
can be viewed and monitored on this Digital Display.
All controls can be adjusted using the SELECT / OK
button and the Up and Down arrows.
Descriptions of the icons used in the display are
shown in Figure 26.
On/O󰀨
Power
Temperature and
Pressure Gauges
Reset
Cancel
SELECT / OK
Up
(next)
Down
(next)
Looping
Scroll
BRUTE LX