Spec Sheet

©2019, Bradford White Corporation. All rights reserved.
For field service, contact your professional installer or local Bradford White sales representative.
Sales 800-523-2931
n
Fax [phone]
Technical Support 800-334-3393
n
Email techserv
@
bradfordwhite.com
Warranty 800-531-2111
n
Email warranty
@
bradfordwhite.com
International: Telephone [phone]
n
Email international
@
bradfordwhite.com / www.bradfordwhite.com
Ambler, PA
Commercial Flue Damper Electronic Ignition Gas Water Heater
Printed in U.S.A.735-C-0619
Sample Specification
The water heater shall be a Bradford White model with a rated storage capacity of not less than_______gallons (_______liters), a minimum gas input of
_______BTU/Hr. (_______ kW), a minimum recovery of _______GPH (_______ LPH). The tank shall be Vitraglas
®
lined and have a bolted hand hole cleanout.
A digital LCD display shall be integrated into the front control box, and the control shall be an adjustable electronic thermostat to any temperature up to
180ºF (85°C) must have an automatic re-set Energy Cut-off (E.C.O), which shuts off all gas in an event of a overheat condition. The tank shall have _______
magnesium anode rods installed in separate tank head couplings. The heater shall have Non-CFC foam insulation, electronic ignition, and come equipped
with an ASME rated T&P relief valve, a cold water inlet Hydrojet
®
Sediment Reduction System, and a automatic flue damper (115V AC required). It shall be
design certified by CSA International for 180ºF (82ºC) application, either with or without a separate storage tank, and comply with state and local codes and
ordinances.
General
All gas water heaters are certified at 300 PSI test pressure (2068 kPa) and 150 PSI working pressure (1034 kPa). All models are design certified by CSA
International (formerly AGA/CGA), ANSI standard Z21.10.3, for up to 180°F (82°C) application as an Automatic Storage Heater, and an Automatic Circulating
Tank Heater. As an Automatic Storage Heater, all models are complete, self-contained water heating systems. It needs no separate storage tank, pump,
wiring or elaborate piping network. When equipped with a mixing valve, it will supply 180°F (82°C) sanitizing and lower temperature general purpose hot water
simultaneously. These models can be used either as a single unit or in multiples connected in series or parallel (recommended).
Dimensions and specifications subject to change without notice in accordance with our policy of continuous product improvement.