Installation / Operation Instruction Manual
Table Of Contents
- WITH TROUBLESHOOTING GUIDE
- Non-Flue Damper Models (Figure 2)
- Flue Damper Models and Non-Flue Damper Models (Figure 3)
- Non-Flue Damper Models (Figure 4)
- Front, sides and Rear “A”
- Input
- 2 in. (5.1 CM)
- Less than or equal to 300,000 BTUH
- 6 in (15.2 CM)
- Greater than 300,000 BTUH
- IMPORTANT-The flow of combustion and ventilating air must not be obstructed.
- MECHANICAL EXHAUSTING OF ROOM AIR - Where an exhaust fan is installed in the same room with this water heater and combustion air is drawn from inside the room, sufficient openings for air must be provided in the walls. UNDERSIZED OPENINGS WILL CAUSE A...
37
2b. Water Temperature - Upper Sensor (Displays if there is an upper sensor – some models)
2c. Water Temperature - Lower Sensor (Displays if there are two sensors)
3. Flame Current of Pilot Flame Sensor (Displays only in the Heating Cycle)
SELECT
SET
Status
Heating
Operational
Flame Current
µA
SELECT
SET
Status
°F
idle
Operational
Upper
Sensor
SELECT
SET
Status
°F
idle
Operational
Lower Sensor