Installation / Operation Instruction Manual

11 238‐50320‐00B 9/15

Cutendofpipetolengthusingahacksaw.Cutmale Deburringcutpipeedgewithrazorknifetoremove
endonlyandallowfor2”insertiondepthintofemaleendof sharpedgestopreventgasketdamage.
fitting.



Step7:Continueinstallingstraightsectionsofpipeandelbowsandsupportwithpipesupportclampsaspreviously
shownoneveryhorizontalpipesectionoratleastevery10feet(3meters)forverticalruns. Runtheventpipenearthe
outsidewallorrooftobeterminated.ADuraVentPVCtoPolyProAdapter(2”,3”or4”diameters)mustbeusedto
connecttheDuraVentpolypropyleneventpipe
toPVCpipefirstbeforeexitingthewallorroof.Thefemaleflaredend
(insidegasket)ofthelastDuraVentpipesectionmustbecutoffattheproperlengthneeded.Connectthefemaleendof 
thePVCAdpaterintotheendofthelastpipe. ConnectthePVCcoupling
overthemalegasketedendofthePVC
TerminationAdapter.SecurethePVCpipecouplingtotheDuraVentPVCadapterwiththeAdapterConnectorClampand
detailedpreviously. CutthePVCpipetothelengthneededtoexitthewallorroof. Refertotheinstallationinstruction
manualsuppliedwiththe
waterheaterforinformationregardingthelocationoftheventterminals.

Cutthemaleendofthelastpieceofpipetothelengthasneededtogetneartheexitingwallorceiling
ofthedesiredoutsideventterminallocation. Installthislastsectionofpipe.
Deburrcutpipewithrazorknifetoremove
sharpedges.