Installation / Operation Instruction Manual

8 238‐50320‐00B 9/15




Step5:DuraVentsuppliedsupportbracketsmustbeusedtosupportthepipesections. Theventpipesectionsmustbe
supportedaminimumofevery10feet(3meters)ofverticalrunoroneveryhorizontalpipesection. Consultlocalcodes
foradditionalrequirements.
DuraVentsuppliestwotypesofapprovedclampsavailableforhangingtheventpipe.ThePolypropylenesnapstyle
clampcanbeattachedateitherthemaleorfemale
endofthepipe.Determinethelocationfortheanchorbolt
mountingtothewallorframingmember. Mounttheanchorboltsuppliedwiththeclamp.Aligntheencapsulatednut
oftheclampwiththeanchorboltandrotatethebodyofclampwiththenutontothethreadsof
theanchorbolt. With
theventpipeinplace,theclampisthensnappedtogetherbyclosingtheclamparoundtheventpipebodyorfemale
endofthepipe.

ThemetalWallStraptypeclampcanonlybemountedonthebodyoftheventpipe.Openthemetal
clamptofitaround
thebodyoftheventpipeandslideintothedesiredlocationtosecuretothewallorceiling. Securetothewallor
structuralmemberbyusing(2)1½”#8woodscrewsorequivalent(notsuppliedwithclamp). Securetheclamparound
theventpipe
bytighteningthenutsandboltsoftheclamp.


WARNING
Make sure pipe sections are fully inserted into the PVC adapter and/or gasketed end of DuraVent fitting. Insertion
depth is no less than 2 inches.
Plasticclamplatchedaround
bodyofventpipe
LagBoltscrewsintowall
studandclampscrews
ontobolt. Clampthen
fastensaroundventpipe.