Installation / Operation Instruction Manual

44
WARNING
Setting the water temperature to the maximum set point can result in scalding hot water delivered to the faucets. It is
highly recommended that the maximum setpoint be adjusted to the lowest temperature possible for the needs of the
installation. See following section to change the maximum setpoint limit (max setpoint). Make sure the water heater
control display is not in a public area that can result in the temperature settings being improperly adjusted. See
previous warning on scalds and an ASSE approved mixing valve.
NOTICE
When the maximum setpoint is reached, the display will show “Max Setpoint” without the setpoint value.
The maximum setting is equal to approximately 180˚F (82˚C).
The default temperature setpoint from the factory is 70˚F (21˚C).