Troubleshoot

Table Of Contents

Other possible solutions:

NOTE: BE SURE ELECTRICITY IS TURNED OFF BEFORE PROCEEDING

STEP ONE:

Make sure the printed circuit board is mounted in the correct position. This is the top

set of mounting holes (See diagram below). Failure to mount PCB in the correct

position will cause element burn out and may cause further damage to the unit

(This board may have been incorrectly positioned if serviced previously).

The correct mounting holes

for the PCB on an “ES,EFC,

EFT” model.

Board mounted in correct

position

Inlet filter

STEP TWO:

Inspect the inlet filter (See diagram above for location). Make sure the inlet filter

screen is free from debris, pipe dope or any other foreign materials that may prevent

adequate water flow.