Installation & Operating Manual

GENERAL OPERATION

TO FILL THE WATER HEATER

1. Close the water heater drain valve by turning the stem clockwise.

2. Open the cold water supply shut-off valve.

3. Open several hot water faucets to allow air to escape from the system.

4. When a steady stream of water flows from the faucets, the water heater is

filled. Close the faucets and check for water leaks at the water heater drain

valve, combination temperature and pressure relief valve and the hot and

cold water connections.

TO DRAIN THE WATER HEATER

Should it become necessary to completely drain the water heater, make sure

you follow the steps below:

1. Shut off the gas supply to the water heater.

2. Turn off/disconnect all electric power to the water heater.

3. Close the cold water supply shut-off valve.

4. Open the drain valve on the water heater by turning the stem counter-

clockwise. The drain valve has threads on the end that will allow the

connection of a standard hose coupling.

5. Open a hot water faucet to allow air to enter the system.

To refill the water heater, refer to “To Fill the Water Heater.”

WARNING

Water heaters are heat producing appliances. To avoid damage or injury

there must be no materials stored against the water heater or vent-air

intake system, and proper care must be taken to avoid unnecessary contact

(especially by children) with the water heater and vent-air intake system.

UNDER NO CIRCUMSTANCES MUST FLAMMABLE MATERIALS,

SUCH AS GASOLINE OR PAINT THINNER BE USED OR STORED IN

THE VICINITY OF THIS WATER HEATER, VENT-AIR INTAKE SYSTEM

OR IN ANY LOCATION FROM WHICH FUMES COULD REACH THE

WATER HEATER OR VENT-AIR INTAKE SYSTEM.