Installation / Operation Instruction Manual

GENERAL INFORMATION

This storage unit must be installed in accordance with local codes. In the

absence of local codes, install this storage unit in accordance with the

N.E.C. Reference Book (latest edition).

The warranty for this storage unit is in effect only when the storage unit is

installed, adjusted, and operated in accordance with these Installation and

Operating Instructions. The manufacturer will not be held liable for damage

resulting from alteration and/or failure to comply with these instructions.

These instructions apply only to this storage unit. Other components of the

system should be installed in accordance with the instructions provided by

the manufacturer.

State and local codes may supersede suggestions made in this Installation

and Operating Instruction manual.

This storage unit shall be used in conjunction with an existing water heater

or hot water boiler.

A sacrificial anode(s) is used to extend tank life. Removal of any anode,

except for inspection and/or replacement, will nullify the warranty. In areas

where water is unusually active, an odor may occur at the hot water faucet

due to a reaction between the sacrificial anode and impurities in the water. If

this should happen, an alternative anode(s) may be purchased from the

supplier that installed this water heater. This will minimize the odor while

protecting the tank. Additionally, the water heater should be flushed with

appropriate dissolvers to eliminate any bacteria.

DANGER

CAUTION

Incorrect operation of this appliance may create a hazard to life and

property and will nullify the warranty.

Do not store or use gasoline or other flammable, combustible, or

corrosive vapors or liquids in the vicinity of this or any other

appliance.