Spec Sheet

EcoStor
™
SC Solar Indirect System
Single Coil Electric Backup Models
The EcoStor
™
Single Coil Models feature:
■ Internal Single Wall Heat Exchanger—Single Wall 1
1
⁄2" O.D. glass coated
(Vitraglas
®
) steel coil. The coil has a heat transfer area of 14.2 sq. ft. and a
stored water volume of 2.5 gal. Maximum supply temperature from the solar
collector must not exceed 250°F.
-- 1" NPT Front Supply and Return Connections.
■ Sensor Wires for Solar Thermistor Connections—Twisted wires are
provided under the Upper and Lower covers. These wires have been
provided as a means for connecting thermistors to a solar controller
(Thermistors and Solar Controller are not provided).
■ Backup Element(s)—A dual, or single backup heating element provides
heat only when solar energy does not satisfy demand. Dual element
models allow entire tank to hold hot water during periods where solar
heating is not available.
■ Factory Installed Hydrojet
®
Total Performance System—Cold water inlet
sediment reducing device helps prevent sediment build up in tank.
Increases first hour delivery of hot water while minimizing temperature build
up in tank.
■ Vitraglas
®
Lining—Bradford White tanks are lined with an exclusively
engineered enamel formula that provides superior tank protection from the
highly corrosive effects of hot water. This formula (Vitraglas
®
) is fused to the
steel surface by firing at a temperature of over 1600°F (871°C).
■ Fully Automatic Controls—Fast acting surface-mount thermostat(s) for
automatic temperature control. Factory installed sensitive manual reset
energy cutoff for safety to prevent overheating.
■ 2" Non-CFC Foam Insulation—Covers the sides and top of tank, reducing
the amount of heat loss. This results in less energy consumption, improved
operation efficiencies and jacket rigidity.
■ Potable Water Connections—3⁄4" NPT factory installed true dielectric
fittings extend water heater life and eases installation.
■ Two Protective Anode Rods—Provide added protection against corrosion
for long trouble-free service.
■ Direct Heat Transfer With Immersed Incoloy Element(s)—Transfers heat
directly and efficiently to the water. Screw-in style.
■ T&P Relief Valve—Included.
■ Low Restriction Brass Drain Valve—Durable tamper proof design.
■ Thermostatic Mixing Valve (ASSE Approved)—Included.
6 Year Limited Tank Warranty / 6-Year Limited Warranty on Component Parts.
For more information on warranty, please visit www.bradfordwhite.com
For products installed in USA, Canada and Puerto Rico. Some states do not allow limitations on warranties. See complete
copy of the warranty included with the heater.
Photo is of
S-SW2-60R6DS
MANUFACTURED UNDER ONE OR MORE OF THE FOLLOWING U.S. PATENTS: 5,682,666; 7,634,976; 5,660,165; 5,954,492; 6,056,542; 6,935,280; 5,372,185; 5,485,879; 5,574,822; 7,971,560; 7,992,526;
6,684,821; 6,442,178; 7,334,419; 7,866,168; 7,270,087; 7,007,748; 5,596,952; 6,142,216; 7,699,026; 5,341,770; 7,337,517; 7,665,211; 7,665,210; 7,063,132; 7,063,133; 7,559,293; 7,900,589; 5,943,984;
8,082,888; 5,988,117; 7,621,238; 7,650,859; 5,761,379; 7,409,925; 5,277,171; 8,146,772; 7,458,341; 2,262,174. OTHER U.S. AND FOREIGN PATENT APPLICATIONS PENDING. CURRENT CANADIAN PATENTS:
2,314,845; 2,504,824; 2,108,186; 2,143,031; 2,409,271; 2,548,958; 2,112,515; 2,476,685; 2,239,007; 2,092,105; 2,107,012. Vitraglas
®
and Hydrojet
®
are registered trademarks of Bradford White
®
Corporation.
501-B-0914-A