Installation & Operating Manual

3
Lighting and Shutdown Instructions
(Replaces pg. 18 in instruction manual.)
not open the inner door and attempt to light the pilot by hand.
any gas control which has been under water.
service technician to inspect the appliance and to replace any part of the control system and
D. Do not use this appliance if any part has been under water. Immediately call a qualified
attempted repair may result in a fire or explosion.
not push in or turn by hand, don't try to repair it, call a qualified service technician. Force or
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will
* If you cannot reach your gas supplier, call the fire department.
* Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
* Do not touch any electric switch; do not use any phone in your building.
* Do not try to light any appliance.
WHAT TO DO IF YOU SMELL GAS.
to the floor because some gas is heavier than air and will settle on the floor.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next
instructions.
A
. This appliance has a pilot which is lit by a electric spark gas ignition system. Do
1. Turn the gas control knob counterclockwise
to the "OFF" position.
causing property damage, personal injury or loss of life.
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
TO TURN OFF GAS TO APPLIANCE
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCETO TURN OFF GAS TO APPLIANCE
FOR YOUR SAFETY READ BEFORE LIGHTING
1. STOP! Read the safety information
at the left on this label.
2. Set the gas control knob to the "OFF" position.
3. Wait five (5) minutes to clear out any gas.
safety information at the left on this label.
If you don't smell gas, go to the next step.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the
6. Look into sight glass window on right inner
4. Remove outer door.
door to view pilot.
5. Locate igniter button.
7. Turn the gas control knob clockwise
H
IGNITER BUTTON
GAS CONTROL KNOB SHOWN
IN THE "OFF" POSITION
8. Depress and hold in gas control knob.
Immediately press igniter button until
Continue to hold down the gas control knob
for about one (1) minute after the pilot is lit.
you hear a "click" sound, then release.
Release the gas control knob it should pop
back out. Check to see if the pilot is still lit
through the sight glass. If the pilot goes out,
repeat steps 2 through 8.
If gas control knob does not pop out when
released, stop and immediately call your
service technician or gas supplier.
If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call
your technician or gas supplier.