Installation Sheet

Installation

P.O. Box 309, Menomonee Falls, WI 53052-0309

TEL. 800.BRADLEY (272.3539) FAX 262.251.5817

bradleycorp.com

P20-160 Rev. B; ECM 11-15-025

Page 1 of 2 1/26/2012

Model 235

Towel Dispenser/Waste Receptacle

Coordinate installation with architect and contractor to avoid protrusion from opposite

wall, pipes vent, conduits, electrical wiring etc. in wall. Follow all applicable local

building codes. If installing where unit projects above top of wainscot, provide

aluminum channel or other ﬁ ller to prevent gap from ﬁ nished wall and ﬂ ange of unit.

For block walls, use metal expansion shields (not included).

Surface-Mounted Unit

(for Recessed and Semi-Recessed

units, see next page)

If necessary, shim at

anchor points to prevent

distortion of unit.

(4) Suitable wall anchors

(not included.)

PAGE 1
Installation Model 235 Towel Dispenser/Waste Receptacle Coordinate installation with architect and contractor to avoid protrusion from opposite wall, pipes vent, conduits, electrical wiring etc. in wall. Follow all applicable local building codes. If installing where unit projects above top of wainscot, provide aluminum channel or other filler to prevent gap from finished wall and flange of unit. For block walls, use metal expansion shields (not included). (4) Suitable wall anchors (not included.
PAGE 2
35 Installation Installation Recessed and Semi-Recessed Dispenser/Waste Receptacle Coordinate installation with architect and contractor to avoid protrusion from opposite wall, pipes vent, conduits, electrical wiring etc. in wall. Follow all applicable local building codes. If installing where unit projects above top of wainscot, provide aluminum channel or other filler to prevent gap from finished wall and flange of unit. For block walls, use metal expansion shields (not included).