Specification Sheet

2903-28
Sensor-Operated Warm Air Hand Dryer
© 2014 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539) [phone]
bradleycorp.com
Orders composed of products indicated as Bradex
®
will be available to ship in three days after receipt of
order at the factory. There is no pricing penalty for
this service from Bradley.
Page 1 of 2 4/16/2013
This information is subject to change without notice.
Bradley_HandDryer_2903-2800_CE
Product Materials
COVER: ¼" (6 mm) thick one-piece cast iron with white porcelain enameled
coating. Cover fixed to the base plate with two vandal-resistant lock screws and
lock with special key wrench.
NOZZLE: chrome-plated zamak. Nozzle is fixed.
MOTOR: universal-type protected by a 4-amp fuse with sealed self-lubricated
ball bearings. Aluminum centrifugal turbine with double symmetrical inlet.
Fireproof plastic UL 94-VO scroll fan.
HEATING ELEMENT: undulated nicrom with a safety thermostat.
ELECTRONIC CONTROL: electronic infrared detection sensor is adjustable
(6"–10"). Switch-off delay is two seconds maximum.
Models 2903-28 and 2903-28CE have a proximity sensor mounted
to the cover near the air outlet with a wire clipped to the base. Before
completely removing the cover, the wire must be unclipped from the
base.
BASE PLATE:
1
⁄8" (3 mm) thick aluminum, with four Ø
5
⁄16" (8mm) holes for
wall mounting.
Installation
Verify all rough-in dimensions prior to installation. Hand dryers require a
dedicated circuit and must be properly grounded. GFI Circuit protection is
recommended. One side of dryer should be mounted to a stud.
Operation
Place hands 3"−6" below nozzle to activate air flow. Dryer will stop two
seconds after hands are removed from air flow.
2903-280000—Standard (110−120 volt, 16 amps,
60 Hz - White)
Bradex
®
2903-2800CE—European Export (220−240 volt, 10
amps, 50 Hz - White)
Recommended for high to very high traffic areas.
®
Guide Specification
Surface-mounted hand dryer shall have a thick cast iron cover with white
porcelain enameled coating and aluminium back base. Hand dryer shall be
fitted with a fixed chrome-plated zamak nozzle, infrared electronic control and
universal-type motor with resilient mounts and sealed, lubricated ball bearings.
Dryer shall operate at 70 dB while delivering 290 CFM of air at 128ºF (53ºC)
and 5,512 LFM velocity during user-controlled drying cycle. The dryer shall
have a total power of 1,850 W (2903-28) or 2,250 W (2903-28CE) with a
consumption of 16 A (2903-28) or 10 A (2903-28CE).
Overall dimensions: 10"H x 11
1
⁄8"W x 8½"D (254mm x 283mm x
216mm).
Weight: 23.35 lb (10.6 kg).