Specification Sheet

2905-2873
Sensor-Operated Warm Air Hand Dryer
© 2014 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539) [phone]
bradleycorp.com
Orders composed of products indicated as Bradex
®
will be available to ship in three days after receipt of
order at the factory. There is no pricing penalty for
this service from Bradley.
Page 1 of 2 11/18/2010
This information is subject to change without notice.
Bradley_HandDryer_2905-2873_CE
Product Materials
COVER:
5
⁄64" (1.9mm) thick steel one-piece cover with white epoxy coating.
Cover fixed to the base with four Allen-head screws.
MOTOR: durable, maintenance-free shaded pole motor with safety thermostat
and self-resetting thermal cut-off at 266ºF (130ºC). PP UL94-V0 with single
inlet fan wheel.
HEATING ELEMENT: waved wire NiCr 40 heating element that incorporates
a self-resetting thermal cut-off at 158ºF (70ºC).
ELECTRONIC CONTROL: two distances (15/25 cm) IR electronic detection
sensor with zamak air outlet grill.
BASE PLATE: thermoplastic ABS UL 94-V0 base and single-inlet centrifugal
scroll fan; with four Ø
5
⁄16" (8mm) holes for wall mounting.
Installation
Verify all rough-in dimensions prior to installation. Hand dryers require a
dedicated circuit and must be properly grounded. GFI Circuit protection is
recommended. One side of dryer should be mounted to a stud.
Operation
Place hands 3"−6" below air outlet grill to activate air flow. Dryer will stop two
seconds after hands are removed from air flow.
2905-287300 Standard (110−120 volt, 13.6 amps, 60 Hz -
White) Bradex
®
2905-2873CE—European Export (220−240 volt, 7 amps,
50 Hz - White)
Recommended for low to mid traffic areas; not recommended
for high vandal-prone areas.
®
Guide Specification
Surface-mounted hand dryer shall be fabricated from one-piece
5
⁄64" (1.9mm)
thick steel. Cover shall have a white epoxy coating. Back base shall be fire-
resistant plastic ABS UL 94-V0. Dryer shall be fitted with an infrared electronic
sensor, zamak air outlet grill and shaded pole motor with safety thermostat
and self-resetting thermal cut-off at 266ºF (130ºC). Dryer shall operate at 60
dB while delivering 194 CFM of air at 125.6°F (52ºC) and 4,181 LFM during
user-controlled drying cycle. Dryer shall have a total power of 1,640 W (2.2
Hp) with a consumption of 13.6 A (2905-2873) or 7 A (2905-2873CE).
Overall dimensions: 11
7
⁄8"H x 10
1
⁄16"W x 5½"D (302mm x 256mm x
140mm).
Weight: 9.8 lb (4,45 kg).