Installation Sheet

Installation
6322, 6324, 6326
Soap Valves
Boutons-poussoirs de savon
Válvulas para jabón
P.O. Box 309, Menomonee Falls, WI 53052-0309
PHONE: 800.BRADLEY (272.3539) bradleycorp.com
Made in Taiwan
P20-105 Rev. G; ECN 17-15-007 page 1 of 2
© 2017 Bradley 3/28/2017
Installation
1. Provide a 1” diameter hole in basin at location where soap dispenser is desired.
2. Insert the shank through the hole in the basin and secure the shank with the neoprene washer,
steel washer, and wing nut provided (1).
NOTE: The shank can be cut to the correct length required.
3. Thread the adapter onto the shank . Then thread the soap container into the adapter.
4. On the plunger and valve assembly, place the square cut end of the supply tube on the cylinder
and tighten the tube on the cylinder with the cable tie provided (2).
NOTE: DO NOT install the angled cut end of the supply tube on the cylinder.
5. Insert the entire plunger and valve assembly with supply tube into the shank mounted to the
basin.
6. Tighten the escutcheon with the wrench provided (1).
Shank
Soap
Container
Adapter (for plastic
soap container only)
Steel
Washer
Neoprene
Washer
Wing
Nut
Escutcheon
Supply
Tube
Cable
Tie
Cylinder
Plunger and
Valve Assembly
Plunger and
Valve Assembly
Shank
Soap
Container
Adapter
Steel
Washer
Neoprene
Washer
Wing
Nut
Escutcheon
Supply
Tube
Cable
Tie
Cylinder
Plunger and
Valve Assembly
Plunger and
Valve Assembly
1
2