Installation Guide

IMPORTANT
To ensure proper operation of your soap dispenser, follow these instructions:
• Once per month, unscrew valve from reservoir and soak it for 30 minutes in hot water.
• Push valve at least 20 times while it is soaking.
• Flush soap reservoir with hot water while valve is soaking.
To obtain a consistent flow and to reduce clogs, use a soap with the following ingredients:
• 80% water
• 10% Bonder (Sodium Laureth Sulfate/Sodium Laurel Ether Sulfate)
• 6% viscosity promoter (ammonium chloride, sodium chloride, glycol disterates, kathon, etc.)
• 3% emollients (aloe extract, jojoba oil, etc.)
• .05% Parachlorometaxylenol (PCMX), Isapropanol, or similar antiseptic ingredient can be
added to produce an antiseptic product.
This soap is available through Champion Brand Products.
If you have any problems with your soap dispensing system, please call a Champion Brand Products
(a division of Lochrie and Associates, Inc.) representative at 1-800-344-5301. They will be happy to
assist you.
To order soap, please contact Champion Brand Products by one of the following
24-hour hotlines:
Telephone: [phone]
FAX: [phone]
www.championbrandproducts.com
215-1286 Rev. C; EN 02-078
Page 1 of 1
Notice to all Bradley Customers!
Bradley Fixtures Corporation recommends the use of Champion brand liquid soap in all of its liquid
soap dispensers. Champion soap has been tested successfully on all of Bradley's liquid soap valves and
is recommended for all hand washing applications. You may purchase Champion soap directly from
Champion Brand Products. Champion has provided the following information regarding the use of its
product. Contact Champion Brand Products for price and order information at any one of the 24-hour
hotline numbers listed below.