Manualshelf

Installation Sheet

ManualsBrandsBradley ManualsSoap DispensersBradley Bradex Sensor Operated Wall Mounted Electronic Soap Dispenser
12
Dimensions (W x H x D)
Soap Tank Capacity { fl oz(ml)}
Battery Type Required
Battery Life Estimated
Room Temperature { °C(°F)}
Sensing Delay Time (msec)
Dispensing Volume { fl oz(ml)}
Applicable Viscosity Range {cP(mPas)}
Unit Net Weight empty { oz(kg)}
Operation Mode
Supply Reservoir Types
Pump Type
4-41/64” x 10-17/32” x 4-11/64” (117.75mm x 267.54mm x 106.09mm)
27(800)
Alkaline (1.5V) C size, Qty 3
100,000 cycles or 1 year
5 ~ 40 (41 ~ 104)
500 ~ 1k
0.034 ~ 0.051 (1 ~ 1.5)
1 ~ 3000 (1 ~ 3000)
24.7 (0.7)
Automatic from Sensor Trigger
800 ml reusable (included)
disposable (supplied by others)
Peristaltic Tube (self contained valve/nozzle)
1. SPECIFICATIONS:1. SPECIFICATIONS:
WALL
DISTANCE
COUNTER TOP
DISTANCE (MINIMUM TYPICAL)
NORMAL COUNTER TOP
At least 7-7/8” (200mm)
STAINLESS STEEL COUNTER TOP
At least 11-13/16” (300mm)
2. RECOMMENDED INSTALLATION:
1.Tape the installation template at the appropriate location on the mounting surface.
2.Drill four (4) holes at marked locations 5 mm
3.Insert four (4) plastic anchors (supplied) into drilled holes; remove template (fig. 1).
4.Insert two (2) screws (supplied) into top plastic anchors and leave 1/8" (3mm) space from
the wall under head (fig. 2 and fig. 3) for hanging dispenser.
5.Hang the dispenser on the two (2) screws through the keyhole slots at backplate top.
6.Use key to unlock and pull forward the housing cover (fig. 4 ).
7.Remove soap reservoir and lock dispenser to wall with remaining two (2) screws
(supplied) through the holes at backplate bottom. Tighten all screws ( fig. 5).
Ø /16” diameter (8 ).
3.1 INSTALLATION STEPS, Tile or Dry Wall
3.2 INSTALLATION STEPS, Adhesive on Mirror
1.Clean mounting surface in area to be installed with isopropyl alcohol.
2.Mark outline of dispenser on mirror with masking tape.
3.Remove paper liners from self-adhesive pads on dispenser backplate.
4.Place unit on mounting surface with even steady pressure and hold for 1 minute.
5.Let tape cure for 10 hours prior to filling dispenser with soap for use.
S
AP
I
PENS R UNTING
T
MPL TEO
D
S E
MO
E
A
Ø 85/16” ( )mm
fig.1
Item 5
Item 6
fig.2
1/8” (3 )mm
fig.3
fig. 4
fig. 5
Auto Soap Dispenser
Model No.: 6A00-110000
1

Summary of content (2 pages)