Installation Sheet

ECN 09-15-0036 Part Number P20-185

Installation Information:

Important Notice: Adjustable Mirror Clips should be installed

into wall studs for maximum support. It is the responsibility of the

installer to select the proper screws and anchors when mounting to

wall studs is not possible. It is also the responsibility of the installer

to determine the safe weight load based on the installation condi-

tions.

Please read entire instructions before installing mirrors

with Adjustable Mirror Clips. Please Follow Instructions Carefully.

STEP 1: Location of Mirror: Mark the location of the mirror on the wall.

STEP 2: Bracket Mounting: Set bracket 1/2" (12.7 mm) in from the edge of the

mirror, mark bracket holes, drill 3/32" (2 mm) hole, then screw brackets on the wall with the

supplied screws.

Square or Rectangular Mirrors with No Bottom Support. Lower bracket mounting. First

fasten upper screw in bracket only, insert clip, and then insert the second screw through the clip and bracket

to supposet the weight. Upper clips can be installed on top or sides to suit taste, leaving top clip adjustable.

PAGE 1
Installation Information: Important Notice: Adjustable Mirror Clips should be installed into wall studs for maximum support. It is the responsibility of the installer to select the proper screws and anchors when mounting to wall studs is not possible. It is also the responsibility of the installer to determine the safe weight load based on the installation conditions. Please read entire instructions before installing mirrors with Adjustable Mirror Clips. Please Follow Instructions Carefully.
PAGE 2
Square or Rectangular Mirrors with Bottom Support. As the weight is supported at the bottom, two top clips or top side clips are all that is necessary. Space clips according to size of mirror. STEP 3: Upper Bracket Mounting Set bracket 1/2" (12.7 mm) in from the edge of the mirror, mark bracket holes, drill 3/32" (2 mm) hole, then screw brackets on the wall with the supplied screws. Insert clips into the bracket far enough to hold in position.